Ok, i will be buying 2 rockford P2's and a kenwood 2 channel 800w max amp, The subs will be running on 8G Wiring that has a 760 watt amp already running on it for my rear 6x9's

Am i going to be running into problems with my 8G wiring and having 2 Amps on it?


And instead of the kenwood 800w (KAC-7251) i might get the kenwood 920w max amp (KAC-7202) would that be to much power running to the subs?

here is what i found out. the subs are 200wrms each. they are single 4 ohm vc and the amp ( go with the 7202) is putting out 150wrms x 2 at 4 ohms. not a lot of power but the setup will work fine. its all the p2s need anyway. you will probably need bigger wire. they probably both accept 8 guage so run a 4 off of the battery and split it to a couple of 8 guage wires.